Wingle User Manual V0.5 Oct. 25, 2019 Wingle User Manual v0.
SIM Installation – Micro SIM Wingle User Manual v0.
Lift up Antenna Board Wingle User Manual v0.
How to Know the Status of Wingle ¢ ¢ LTE Wi-Fi u u LTE Wi-Fi Wingle User Manual v0.4 3 Wi-Fi LED will turn Red when no SIM card is inserted, or is not inserted correctly, or is not readable. Wi-Fi LED will trun Blue when SIM card is ready and LTE LED will start blinking in Green for PLMN searching and network attaching automatically. LTE LED will stay in Blue/Green/Orange(depends on LTE signal strength) when Wingle is connected to network.
USB Interface ¢ ¢ Remote NDIS is used. Windows 7, 10, Mac OS shall support RNDIS driver. An Ethernet interface will show up if RNDIS driver installed successfully. DHCP IP, 192.168.0.10, will be assigned. The RNDIS driver is supported by MAC OS and Window 7/10. If your machine does not have RNDIS driver installed, please check OS vendor website for help. For Linux OS, please check if RNDIS driver is available. To support Linux CDC-ECM/CDC-EEM driver, please contact with Sales for assistance.
How to Get LTE Information Steps: 1. Connect Wingle to laptop/PC via USB interface or Wi-Fi 2. Visit http://192.168.0.1:8080 3. LTE information will show Wingle User Manual v0.
How to Configure APN Name Steps: 1. Connect Wingle to laptop/PC via USB interface or Wi-Fi 2. Visit http://192.168.0.1:8080 3. Click 'LTE' on the left menu 4. Click 'Setting‘ 5. Configure APN Name/ Username/ Password if required 6. Click 'Apply' 7. Reboot the device Wingle User Manual v0.
How to Configure Wi-Fi AP Steps: 1. Connect Wingle to laptop/PC via USB interface or Wi-Fi 2. Visit http://192.168.0.1:8080 3. Click 'WiFi' on the left menu 4. Click 'AP Setting‘ 5. Configure SSID and other settings 6. Click 'Apply' to take effect Wingle User Manual v0.
How to Upgrade Firmware Steps: 1. Connect Wingle to laptop/PC via USB interface or Wi-Fi 2. Visit http://192.168.0.1:8080 3. Click 'System' on the left menu 4. Click 'Firmware Update' 5. Select Firmware file 6. Select Update Package Format 7. Click 'Update' Wingle User Manual v0.
Check LED Status LED Status Description None Power Off/ System booting Wi-Fi LED Always RED Invalid (U)SIM, SIM card not insterted or PIN locked Wi-Fi LED Always Blue Wi-Fi working LTE LED Always Blue LTE connected and in good signal quality LTE LED Always Green LTE connected and in normal signal quality LTE LED Always Orange LTE connected and in poor signal quality Wingle User Manual v0.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
