IP3442M WiFi Router Quick Start Guide P/N: 957DFR00E5 Document Version: 1.0 Copyright 2020. All Rights Reserved.
Package Contents The following items are included in the box: 1. IP3442M 2. Quick Start Guide 3. Power adapter / 4. Wifi credential card If any of these items are damaged or missing, please contact your service provider immediately.
1 Chapter 1 Introduction This chapter provides details of the IP3442M's features and capabilities. Overview The IP3442M is designed to enhance the connectivity between your WiFi router and wireless client device while increasing the coverage of your existing WiFi network. With its simple setup, this high-speed 802.11ac extender works seamlessly with most routers. Features Easy Setup: WPS button setup or web browser configuration Wireless Features Supports 11ac WiFi: 802.
2 Chapter 2 Basic Setup This chapter provides details on how to setup the IP3442M Front Panel Figure 1: Front Panel 1. Power/WAN (Green/Red) Red On, Green off – No internet. Blink Red,Green off - The Power LED will blink(Red) during boot up Green On, Red off-Internet connection is available. Interleave Red and Green-FW upgrade Off - No power. 2. WiFi/ WPS LED (Blue/Green) Green On-Wireless enable. Green off-Wireless disable Blue Slow blink, Green off - WPS is pairing.
Back Panel Figure 2: Back Panel 1. LAN port*3 Connect to a PC or other Ethernet device using a standard Ethernet cable. 2. WAN port Connect to a cable modem or PON using a standard Ethernet cable. 3. Reset Button 4.USB port This button is recessed; a pin or paper clip can be used to press it. The button can be used while the unit is powered and the power LED is Green. Reset to manufacturer default values and reboot.
Side Panel Figure 3: Back Panel WPS Button Push the WPS button on the device and on your other WiFi device to perform WPS function that easily creates an encryption-secured WiFi connection automatically.
Setup the IP3442M You can set up your IP3442M using web browser. 2 Setup Using Web Browser Step 1: Make sure the WiFi router is on and working properly. Step 2: Connect the Router WAN port with your cable modem or PON device with an Ethernet cable. Step 3: Connect an Ethernet cable to the Router and your PC. Step 4: Launch the browser and enter http://192.168.1.1 in the Address box. Step 5: You will be prompted for a username and password.
3 Chapter 3 Safety This chapter provides you some safety operation warnings . 1. Use the power supply adapter provided in the package only. Using any other adapters may cause damage to the equipment or result in operation failures. 2. The electrical load capacity of the socket and cables should meet the device’s requirement. Power socket overload, broken cables or broken plugs may cause electric shock or fire. Check the power supply wires and cables regularly. 3.
A Appendix A Regulatory FCC Statement This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
