User's Manual

4
Rear - iCamera2
Figure 2: Rear Panel
1. LAN Port Use standard Ethernet cable (RJ45 connectors) to connect your PC
to the port for installation and configuration. The port is also used
for power connection when the camera is under wireless mode. A
customized PoE (Power over Ethernet) splitter, as a Y-cable, for
both Ethernet and DC Jack is provided.
2.WPS/Reset
This button has two (2) functions:
• WPS.
• WPS PBC Mode
1. Turn on the camera without connecting the Ethernet cable.
2. Wait for three minutes, and then press and release (less then 3
seconds). The WPS LED will start blinking. Press the WPS
button on the gateway within two minutes.
3. The WPS LED will be off and the Network LED will be on if
the connection is successful.
• WPS Pin Code Mode
1. Turn on the wireless camera without connecting the Ethernet
cable.
2. Wait for three minutes, and then press and hold the button for
over three seconds (3 ~ 10 seconds). The WPS LED will start
blinking.
Get the pin code in the "WSC PIN Code" field of Wireless
screen (camera’s web interface). Enter the pin code on the
gateway within two minutes.
3. The WPS LED will be off and the Network LED will be on if
the connection is successful.
• Reset.
1. Power On.
2. Keep holding the button down for 10 seconds, then release.
3. Microphone
The built-in microphone is located on the rear of the device.