User's Manual

3
Physical Details - iCamera2
Front - iCamera2
Figure 1: Front Panel
1. Light Sensor
This is hardware sensor to detect LUX.
2. Lens No physical adjustment is required or possible for the lens, but you
should ensure that the lens cover remain clean. The image quality is
degraded if the lens cover is dirty or smudged.
3. POWER/WiFi
indicator (Green)
On (Green) - Power is on.
Off - Power is off.
Flashing - Wifi signal-strength indication.
The LED indicates SNR for the first 5 minutes after the camera is
powered on. Then it will stay solid to indicate power LED for 5
minutes when wireless setup is ready.
• Flashing Low at 1/2Hz - WiFi signal is weak, SNR < 15 dB
• Flashing Middle at 2Hz - WiFi signal is acceptable, SNR
15-22 dB
• Flashing High at 5Hz - WiFi signal is strong, SNR > 22 dB
4. Network
indicator (Green)
On - LAN/Wireless connection established.
Off - No active connection on the corresponding LAN port, or not
associated to Wireless AP.
Flashing - Data is being transmitted or received.
5. WPS indicator
(Green)
On - If the WPS association fails, the WPS LED will be on
continuously for 5 seconds.
Off - WPS function is off.
Flashing - WPS association is in process. The LED goes off when
the connection is complete.