User's Manual

Step 2 - Installation

Figure 4: Installation

1. Disassemble the Camera

Unplug the Y-cable and power off the camera.

2. Connect the Ethernet cable

Connect the Ethernet cable to the LAN port of the iCamera2.

3. Power Up

Connect the DC cable to the Ethernet cable.

Connect the supplied power adapter to the DC cable to power up the iCamera2. Use only

the power adapter provided. Using a different one may cause hardware damage.

4. Check the LEDs

• The Power LED will turn on briefly, then start blinking. It will blink during startup, which

takes 15 to 20 seconds. After startup is completed, the Power LED should remain ON.

• The Network LED should be ON.

For more information, refer to Physical Details - iCamera2 in Chapter 1.