User's Manual

1. Assemble the Camera

a. Hold the metal screw of the stand up.

b. Face the back of the iCamera2 to the stand and turn the iCamera2 clockwise to attach

it to the stand.

2. Connect the Y-cable

Connect the provided Y-cable (with Ethernet) to the LAN port of iCamera2.

The wireless and wired modes cannot work

simultaneously. It is recommended to first

configure the wireless settings of an iCamera2

using wired mode. After configuration, disconnect

the wire and power, and power on the iCamera2

again. Then, it will be ready for wireless operation.

3. Connect the Router

Use the Ethernet cable to connect the Y-cable and connect the other end to the LAN port

of the router.

4. Power Up

Connect the supplied power adapter to the Y-cable and power up. Use only the power

adapter provided. Using a different one may cause hardware damage.

5. Check the LEDs

• The Power LED will turn on briefly, then start blinking. It will blink during startup, which

takes 15 to 20 seconds. After startup is completed, the Power LED should remain ON.

• The Network LED should be ON.