User's Manual

DRG600WiFi User Guide Advanced Features
Page 79 of 104
Routing Screen
The routing table is accessed by the Routing tab of the Advanced menu.
Generally, you will use either RIP (Routing Information Protocol) OR the Static Routing Table, as explained
above, although it is possible to use both methods simultaneously.
Static Routing Table
If RIP is not used, an entry in the routing table is required for each LAN segment on your Network, other than
the segment to which this device is attached.
The other Routers must also be configured. See Configuring Other Routers on your LAN later in this chapter for
further details and an example.
Figure 39. Routing Screen
RIP
Enable RIP v1
Check this to enable the RIP (Routing Information Protocol) feature of the DRG600-
W
iFi. The DRG600-WiFi supports RIP 1 only. Click the “Save” button to save this
RIP setting. This has no effect on the Static Routing Table.
Static Routing
This list shows all entries in the Routing Table. Details for the selected item in the list will be displayed in the
Properties fields.