User's Manual

DRG600WiFi User Guide Status
Page 58 of 104
PPPoE Link Status
This indicates whether or not the connection is currently established.
If the connection does not exist, the "Connect" button can be used to establish a
connection.
If the connection currently exists, the "Disconnect" button can be used to break the
connection.
Connection Log
Connection Log
The Connection Log shows status messages relating to the existing connection.
The most common messages are listed in the table below.
The "Clear Log" button will restart the Log, while the Re-
fresh button will update the messages shown on screen.
Buttons
Connect If not connected, establish a connection to your ISP.
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make it easier to read new messages.
Refresh Update the data on screen.
Connection Log Messages
Message Description
Connect on Demand
Connection attempt has been triggered by the "Connect automatically, as
required" setting.
Manual connection Connection attempt started by the "Connect" button.
Reset physical connection Preparing line for connection attempt.