User's Manual

DRG600WiFi User Guide Setup
Page 32 of 104
ESSID (Extended Service Set Identifier).
To communicate, all Wireless stations should use the same SSID/ESSID.
Options
Mode
Auto - This is the default, and should normally be used. Both 802.11b and 802.11g
wireless stations can use the wireless network..
802.11g - Only 802.1 1g Wireless stations can use the Wireless
Router.
802.11b - Only 802.11b connections are available. 802.11g
Wireless Stations will only be able to use the DRG600-WiFi if they are fully backward-
compatible with the 802.1 1b standard.
Channel No.
This field determines which operating frequency will be used. It should not be necessary
to change the wireless channel unless you notice interference problems with another
nearby access point. The default is Auto.
Broadcast SSID
If Enabled, the SSID will broadcast its name to all Wireless Stations. Stations which have
no SSID (or a "null" value) can then adopt the correct SSID for connections to this
Access Point..
DTIM Interval
(Advanced feature) Increasing DTIM interval allows wireless clients to conserve power
more effectively but may increase delays in reception of multicast traffic.
Power setting
Adjusts the power strength of the wireless signal. Reduce the power strength may reduce
the wireless coverage.
Wireless Security
Current Setting
The current wireless security encryption method is displayed.
Default value is WPA-PSK. Click the “Configure” button to to access the Wireless
security sub-screen, and modify the security settings as required. See “Wireless Security
Screen” on page 34 for more details.
Access point
Enable Access When this setting is selected, traffic is allowed to pass according to the following: