User's Manual

DRG600WiFi User Guide Setup
Page 26 of 104
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is shown below.
Figure 7. LAN Screen
TCP/IP
IP Address
IP address for the DRG600-WiFi, as seen from the local LAN. Use the default value
unless the address is already in use or your LAN is using a different IP address range. In
the latter case, enter an unused IP Address from within the range used by your LAN.
Subnet mask
The default value 255.255.255.0 is standard for small (class "C") networks. For other
networks, use the Network Mask for the LAN segment to which the DRG600-WiFi is
attached. i.e. the same value as the PCs on that LAN segment.
DHCP Server
If Enabled, the DRG600-WiFi will allocate IP Addresses to PCs (DHCP clients) on your
LAN when they start up. The default (and recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be Disabled, and the existing
DHCP server must be re-configured to treat the DRG600-WiFi as the default Gateway.
See the following section for further details.
The Start IP Address and Finish IP Address fields set the values used by the DHCP
server when allocating IP Addresses to DHCP clients. This range also determines the
number of DHCP clients supported.
See the following section for further details on using DHCP.
Save This button saves any changes you have made. Note that if you change the DRG600-