User's Manual

DRG600WiFi User Guide Setup
Page 20 of 104
4. To connect to the DRG600-WiFi, logon with the user name admin. There is no password by
default. Click OK.
If you cannot connect to the DRG600WiFi setup webpage
If the DRG600-WiFi does not respond, check the following:
• The DRG600-WiFi is properly attached,WLAN/LAN and Power LEDs are ON.
• You can test the connection by using the "Ping" command. To do this:
1. Open the MS-DOS window or command prompt window.
2. Enter the command: ping 192.168.0.1
If no response is received, either the connection is not working, or your PC IP address is not compatible
with the DRG600-WiFi IP Address. (See next item.)
3. If your PC is using a fixed IP Address, its IP Address must be within the range 192.168.0.2 to
192.168.0.254 to be compatible with the DRG600-WiFi default IP Address of 192.168.0.1. Also, the
Network Mask must be set to 255.255.255.0. See PC Configuration on page 40 for details on checking
your PC TCP/IP settings.
• Ensure that your PC and the DRG600-WiFi are on the same network segment. (If you don't have a router,
this must be the case.)
• Ensure you are using the wired LAN interface.