User's Manual

DRG600WiFi User Guide Setup
Page 19 of 104
• Default Config
• Logs
• Network Diagnostics (Ping, DNS Lookup)
• Local Administration
• Upgrade Firmware
Configuration Program
The DRG600-WiFi contains an HTTP server. This enables you to connect to the server and configure the device
using your web browser. Your browser must support Javascript.
The configuration program has been tested on the following browsers:
• Safari version 1.2 or later
• Firefox version 2.0 or later
• Internet Explorer version 6.0 or later
Preparation
Before attempting to configure the DRG600-WiFi, please ensure that:
Your PC can establish a physical connection to the DRG600-WiFi. The PC and the DRG600-WiFi must be
directly connected (using the LAN ports on the DRG600-WiFi) or on the same LAN segment.
The DRG600-WiFi must be installed and powered ON.
Using UPnP
If your Windows system supports UPnP, an icon for the DRG600-WiFi will appear in the system tray, notifying
you that a new network device has been found, and offering to create a new desktop shortcut to the newly-
discovered device.
Unless you intend to change the IP Address of the DRG600-WiFi, you can accept the desktop shortcut.
Whether you accept the desktop shortcut or not, you can always find UPnP devices in My Network Places
(previously called Network Neighborhood).
Double-click the icon for the DRG600-WiFi (either on the Desktop, or in My Network Places) to start the
configuration. Refer to the following section Setup Wizard for details of the initial configuration process.
Using your Web Browser
To establish a connection from your PC to the DRG600-WiFi:
1. After installing the DRG600-WiFi and any LAN devices, start your PC. If your PC is already
running, restart it.
2. Start your WEB browser.
3. Go to
http://drg600.wifi or use the DRG600-WiFi IP Address: http://192.168.0.1
The Login screen will appear.