User's Manual

DRG600WiFi User Guide Installation
2. Connect LAN Cable
Use the supplied standard LAN cable to connect a PC to one of the LAN ports on the bottom of the
DRG600-WiFi.
If required, connect any port to a normal port on another Hub, using a standard LAN cable. Any
LAN port on the DRG600-WiFi will automatically function as an "Uplink" port when required.
3. Check the LEDs
• The Power LED should be GREEN. (If it is RED, then the Internet connection is not
available, you can still run the configuration software as this is stored on the device itself).
• The WLAN LED should be GREEN
• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
For more information, refer to Top-mounted LEDs in Chapter 1.