User's Manual

Chapter 3

Access Point Setup

This Chapter provides details of the Setup process for Basic Operation of

your Wireless Access Point.

Overview

This chapter describes the setup procedure to make the Wireless Access Point a valid device

on your LAN, and to function as an Access Point for your Wireless Stations.

Wireless Stations may also require configuration. For details, see Chapter 4 - PC and Server

Configuration.

The Wireless Access Point can be configured using your Web Browser.

Setup using a Web Browser

Your Browser must support JavaScript. The configuration program has been tested on the

following browsers:

 Chrome

 Firefox

 Internet Explorer 7 or later

Setup Procedure

Before commencing, install the Wireless Access Point in your LAN, as described previously.

1. Check the Wireless Access Point to determine its Host Name. This is shown on a label on

the base or rear, and is in the following format:

APxxxxxx

Where xxxxxx is the last 6 Hex characters (0 ~ 9, and A ~ F) of the MAC address.

2. Use a PC which is already connected to your LAN, either by a wired connection or anoth-

er Access Point.

 Until the Wireless Access Point is configured, establishing a Wireless connection to it

may be not possible.

 If your LAN contains a Router or Routers, ensure the PC used for configuration is on

the same LAN segment as the Wireless Access Point.

3. Start your Web browser.

4. In the Address box, enter "HTTP://" and the IP Address of the 11N Wireless Access Point,

as in this example, which uses the Wireless Access Point's default IP Address:

HTTP://192.168.0.228

5. You should then see a login prompt, which will ask for a User Name and Password.

Enter admin for the User Name, and password for the Password.

These are the default values. The password can and should be changed. Always enter the