User's Manual

Wireless ADSL Router User Guide

If you can't connect

If the Wireless ADSL Router does not respond, check the following:

• The Wireless ADSL Router is properly installed, LAN connection is OK, and

it is powered ON. You can test the connection by using the "Ping" command:

• Open the MS-DOS window or command prompt window.

• Enter the command:

ping 192.168.0.1

If no response is received, either the connection is not working, or your

PC's IP address is not compatible with the Wireless ADSL Router's IP

Address. (See next item.)

• If your PC is using a fixed IP Address, its IP Address must be within the range

192.168.0.2 to 192.168.0.254 to be compatible with the Wireless ADSL

Router's default IP Address of 192.168.0.1. Also, the Network Mask must be

set to 255.255.255.0. See Chapter 4 - PC Configuration for details on check-

ing your PC's TCP/IP settings.

• Ensure that your PC and the Wireless ADSL Router are on the same network

segment. (If you don't have a router, this must be the case.)

• Ensure you are using the wired LAN interface. The Wireless interface can only

be used if its configuration matches your PC's wireless settings.

Setup Wizard

The first time you connect to the Wireless ADSL Router, you should run the Setup Wizard to

configure the ADSL and Internet Connection.

1. Click the Setup Wizard link on the main menu

2. On the first screen, select Auto-detect or Manual Selection, then click "Next"

Figure 5: Setup Wizard Home Page

3. If Manual Selection is selected, you will see the VC 1 screen shown below. Enter the VPI

and VCI values provided by your ISP, then click "Next".