User's Manual

Page 5
LED Indicators
All models have two LED indicators on the top. The Error LED is orange or red. The Status
indicator LED is green. The LED indicator modes are described in the following table.
Status Error Description
Solid Off Solid Off No power
Solid On Solid On Hardware error
Solid On Solid Off Normal operation (Idle)
Blinking Blinking Firmware upgrade in progress
(the two LED blink in sequence)
LEDs - PS723H
The PS723H has additional LEDs as follows:
LED Description
Power OFF - no power
ON - normal operation; power On.
10 ON - Indicates the LAN connection is using 10BaseT.
Flashing - Data is being transmitted or received via the LAN port.
100 ON - Indicates the LAN connection is using 100BaseT or 100BaseTX.
Flashing - Data is being transmitted or received via the LAN port.
WLAN ON - Wireless Access Point is available; PCMCIA wireless card is
working correctly.
OFF - Wireless Access Point is not available. The PCMCIA wireless
card is not working correctly.
Flashing - Data is being transmitted or received via the Wireless Access
Point.
LEDs - PS7100
The PS7100 has 2 additional LED indicators as follows:
LED Description
WLAN ACT Off - Idle
Flashing - Transmitting or receiving data through the Wireless
LAN.
LAN ACT Off - Idle
Flashing - Transmitting or receiving data through the LAN.
Diagnostic Push Button
The Print Servers are fitted with a Diagnostic Push Button. The button is recessed; a pin or
paper clip can be used to press it. This button has 2 functions:
• Restore the factory default settings