User's Manual

Page 49
IPP Client Setup - Windows 2000
Windows 2000 has its own IPP Client, and there is no need to install the supplied IPP Client
Software. To use Windows 2000's IPP Client with the Print Server, follow this procedure:
1. Start the Add Printer wizard.
2. Select Network Printer, and click "Next" to see the Locate your Printer screen, as shown
below.
Figure 23: Windows 2000 - Locate your Printer
3. Select Connect to a printer on the Internet or on your Intranet, and enter the URL of the
IPP Server as follows, where ip_address represents the IP Address of the IPP Server,
and 631 is the port number.
Parallel Port 1
ip_address:631/ipp/P1
Parallel Port 2 (if exists)
ip_address:631/ipp/P2
Parallel Port 3 (if exists)
ip_address:631/ipp/P3
These entries are case sensitive. They must be entered as
shown, with "ipp" in lower case, and P1, P2 and P3 in
UPPER case.
4. If the connection can be established, and the printer on that port is on-line, the following
dialog will be displayed.
Figure 24: Windows 2000: No printer driver
5. Click "OK", and then select the printer manufacturer and model to match the printer
connected to the port on the IPP Server.