User's Manual

Page 42
Wireless Stations
Access
Permission
• "No access - block everyone" prevents this device being used as a
Wireless Access Point.
However, Wireless users can still access the connected printer or
printers. (They must have the correct SSID.)
• If "Allow Everyone access" is selected, no check is performed on
the station address before allowing it to use this Access Point.
• If "Only allow access if on this list" is selected, then a Wireless
station must be an address which occurs in the address list, or it
will not be allowed access.
Existing Stations This lists the Wireless stations you have entered. If you have not
entered any stations, this list will be empty.
New Station To add a new station to the list, enter its address here, and click the
Add button. The address will look like this example:
10:98:10:98:10:91
On Windows, you can determine the address using WinIPCfg, as
follows:
• Use Start - Run to open the "Run" dialog.
• Type WINIPCFG and press Enter (or click OK).
• WinIPCfg will then run, as shown below.
• Select your Wireless adapter from the drop-down list. The address
is shown on the Adapter Address field.