User's Manual

Page 32
You should select ONE protocol only.
Find Use this option to use the IPX/SPX protocol to locate a Print Server on
the LAN. Simply enter the Default Name of the Print Server you wish
to locate. The Default Server Name is shown on a sticker on the base of
the device.
Reset Device This will cause the device to reboot. This should be done after making
any configuration changes, or if the device stops responding after some
problems.
Restore Factory
Default
This will restore ALL device values to their factory defaults. To restore
only the current screen, use the Set to Default button on the screen.
Set IP Address For TCP/IP networks only:
• If a Print Server does not appear on the main screen, use this
option to set a Device IP Address, Gateway IP Address, and
Network Mask to the Print Server.
• This should only be necessary if your LAN is using ONLY the
TCP/IP protocol. In other cases, BiAdmin will use IPX/SPX to
locate the Print Server even if it doesn't have a valid IP Address.
• To locate the Print Server, enter the Default Name. The Default
Server Name is shown on a sticker on the base of the device.
• Enter the required IP Address, Network Mask, and Gateway IP
Address.
• After saving the data to the device, refresh the listing. The Print
Server should then appear in the device list on the main screen.
Upgrade Upgrade the firmware in a Print Server. See Upgrade Icon for details.