User's Manual

Page 20
5. The LAN will be searched for Print Servers, and a screen like the following will be
displayed.
• If desired, change the Workgroup name and click Refresh.
• Select List all Print Servers to list all Print Servers, regardless of Workgroup.
• The name of the attached printer will be displayed if possible. If "No printer" is
displayed, check that the printer is properly connected and powered on.
Figure 5: Add Port (Peer-to-peer Print Driver)
If your Print Server is not listed:
• Select "List all Print Servers", and click the "Refresh" button.
• Check that both the Print Server and the printer are properly connected, and
powered on.
• Check that the Print Server has been configured, using the Administrator
installation option on the CD-ROM, and the resulting Setup Wizard.
• If using TCP/IP, try installing the NetBEUI protocol. See the earlier section
Checking your Network Protocols for details. Then uninstall and re-install
the Peer-to-peer Print Driver.
6. Select the desired printer port, and then click the "Next" button. A pop-up message will
inform you if the port has been created successfully.
If you see the following error message, either install Internet
Explorer 4 or later, or follow the procedure in the "Trouble
Shooting - Windows" section of Chapter 8.
7. Then a screen like the following will be displayed: