User's Manual

Page 14
Model PS723H
The PS723H has the ability to act as a Wireless Access Point. This section applies only to the
PS723H.
To allow Wireless Stations to use the Access Point, the Wireless Stations and the Access Point
must use the same settings, as follows:
Mode On client Wireless Stations, the mode must be set to "Infrastructure".
(The Access Point is always in "Infrastructure" mode.)
SSID (ESSID) Wireless Stations must use the same SSID (ESSID) as the Access Point
they wish to connect to.
WEP The Wireless Stations and the Access Point must use the same settings
for WEP (Off, 64 Bit, or 128 Bit).
WEP Key: If WEP is enabled, the Key Table (for 64 Bit encryption) or
Key (for 128 Bit Encryption) must be the same on the Wireless Stations
and the Access Point.
WEP Authentication: If WEP is enabled, all Wireless Stations must
use the same setting as the Access Point (either "Open System" or
"Shared Key").
You can change either the PS723H, or your Wireless Stations, to ensure that these settings
match.
Changing Wireless Settings on the PS723H
To change the default settings on the PS723H, use either of the following methods:
• BiAdmin Windows Utility. See Chapter 5 for details on installing and using BiAdmin.
• Web Interface. See Chapter 6 for details of using the Web Interface.
BiAdmin Wireless Screen
Installation and use of the BiAdmin Windows utility is described in Chapter 5.
Clicking the Wireless icon, or selecting Configuration - Wireless on the menu, will display the
following screen.