User's Manual

Page 9
3. Within the Setup Wizard, select the Print Server you wish to configure, click Next, and
step through the Wizard.
If the desired Print Server is not listed:
• Check all cables to the Print Server.
• Check the Print Server's LEDs:
• The Red LED should be OFF and the Green LED should be ON or flashing.
• If your model supports 10BaseT and 100BaseT, check the 10/100BaseT link LED
next to the LAN connection. If the auto negotiation fails, the 10/100BaseT Link LED
will not light when the device is powered up. (If there are 2 LEDs, neither will light.).
• Check that your PC and the Print Server are on the same LAN segment. (If you don't have
a Router or Gateway on your LAN, you only have 1 segment.)
• Check that your PC has either the TCP/IP or NetBEUI network protocols installed. See
Checking your Network Protocols in Chapter 4 - Client PC Setup for details.
• If you PC can't configure the Print Server correctly (in Infrastructure mode), then try to
connect to LAN and disable the Wireless.
Alternatives to the Windows Wizard
If you do not have a Windows 32 platform available, use one of the following methods to
configure the Print Server.
Web Browser See Chapter 6 - Web Interface Setup for details.
FTP Using this method, the configuration file is downloaded from the Print
Server, edited, then sent back. No software needs to be installed.
See the UNIX manual for details. The Unix manual is on the CD-ROM,
in the Manual\Unix folder