User's Manual

Page 6
3
Chapter 3
MFP Configuration
This chapter provides an overview of the configuration process.
Overview
The MFP Print Server is designed to support many different platforms, and the configuration
required would depend upon the environment in which it is installed.
• The MFP Print Server usually requires configuration, but if there's a DHCP server on your
network, then the device is just plug-and-play. A Windows-based setup Wizard is also
provided on the CD-ROM to simplify this task.
• PCs wishing to use the printer attached to the MFP Print Server always require
configuration.
Configuration Methods
The following methods are available to perform the required MFP Print Server configuration:
• Windows-based Wizard - see below for details.
• Web-based setup - see Chapter 4 for details.
Using the Windows Wizard
The Windows-based Wizard is supplied on the CD-ROM, and runs on Windows XP and
Windows Vista.
Using this Wizard is the recommended method to configure the MFP Print Server.
It can be used configure the Print Server for your Network environment, even if the MFP Print
Server does not have a valid IP address.
Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start
automatically, run SETUP.exe in the root folder.
2. On the first screen, shown below, click Setup Wizard.