User's Manual

Page 4
LED Indicators
The Print Servers have LED indicators on the top. The Error LED is red. The Status indicator
LED is green. The LED indicator modes are described in the following table.
Status LED
(Green)
Error LED
(Red)
Status Description
Off Off No power.
On Off Normal operation - Idle.
Flashing Off Normal operation - transmitting or receiving
packets from the network.
On On Hardware error.
Flashing Flashing Firmware upgrade in progress.
LED Description
WLAN Off - No Wireless connection available.
On - Wireless connection available.
Flashing - Transmitting or receiving data through the Wireless
LAN.
LAN Off - No LAN connection
On - LAN connection available.
Flashing - Transmitting or receiving data through the LAN.
Diagnostic Push Button
The button is recessed; a pin or paper clip can be used to press it. This button has 2 functions:
• Restore the factory default settings
• Print a test page containing all current settings.
To restore the factory default settings:
1. Turn the Print Server OFF.
2. Press and hold the diagnostic button. While pressing the button, switch the Print Server
ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will be printed,
showing the new (default) settings.
To generate a Diagnostic print out
1. Ensure that both the Print Server and the attached printer are ON.
2. Press the diagnostic button, and hold it in for 2 seconds.
3. The test page, containing the current settings, will be printed.
Note: