User Manual

ManualsBrandsSercel ManualsElectronicsWireless acquisition unit for seismic data

Unit User Manual

VIB-E-DD-389A-0.1

11 July 2007

Summary of content (6 pages)

PAGE 1
Unit User Manual VIB-E-DD-389A-0.
PAGE 2
Copyright Information: This document may not in whole or part be copied, reproduced, or reduced to any medium without prior consent, in writing, from Vibration Technology Ltd. Disclaimer: Every effort has been made to ensure the accuracy of the material provided herein; however Vibtech assumes no responsibility regarding the use of the material. Additionally, Vibration Technology Ltd. shall not be liable for any misuse of this product.
PAGE 3
1 1.1 2 INTRODUCTION ..................................................................................................................................... 4 Related Documents.............................................................................................................................. 4 ELECTRICAL INTERFACE AND CONNECTORS................................................................................... 4 2.1 Pin Numbering ....................................................................
PAGE 4
1 Introduction This User Manual contains some important information about the Vibration Technology Ltd seismic data acquisition Unit. It is important that you read the information contained herein before putting your Unit into operation. 1.1 Related Documents VIB-E-US-388 VIB-E-US-390 VIB-E-PC-146 VIB-E-US-389 2 2.
PAGE 5
3 LEDs State Critical Low Battery Bootloader fails to start Bootloader fail Critical internal failure (e.g. boot test fail) Low (or no external) battery + Sensor Resistance pass Running correctly (e.g. booted) + Sensor Resistance pass Low (or no external) battery + Sensor Resistance fail Running correctly (e.g.
PAGE 6
5.1.3 IC Compliance Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been designed to operate with an antenna having a maximum gain of 9dBi. Having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.