Quick Start Guide

Looping
You have up to 8 loops per track in Serato DJ, and the choice between
either manual or auto loops. You can choose whether you have 4 loops (and
4 cuepoints) showing on screen, or 8 loops. To switch between Manual and
Auto looping, click (Manual) or (Auto) onscreen. You can also
half or double the loop length in either manual or auto modes. Press the
1/2X button onscreen to half the loop length, hold the 2X button to double
the loop length, or you can use the Loop Size knob on the controller to do
the same.
Pad 7 Turn selected Loop on and off 8 Bar Loop Roll
Pad 8 Select next loop slot 16 Bar Loop Roll
NOTE: The best way to edit the in and out points of a manual loop is with
the jog wheel/platter on your Reloop Terminal Mix 4.
NOTE: You can also save a loop to the next available free loop slot in the
software. To do this, either click the button in the manual/auto loop tab
or click on an available loop slot. Your loops are saved to the le and
recalled the next time it is loaded. They are not lost if the le is moved or
renamed.
Reloop Terminal Mix 8
Control
Auto Loop Mode
ON/TAP Turns Auto Loop ON/OFF
LOOP SIZE/BEATS Adjusts Loop length
NOTE: Manual Loop and Loop Roll options are done using the Performance Pads.
Reloop Terminal
Mix 8 Control
Manual Loop Mode Loop Roll Mode
Pad 1 Trigger Loop/Reloop 1/8 Bar Loop Roll
Pad 2 N/A 1/4 Bar Loop Roll
Pad 3 Duplicate selected Loop to next slot 1/2 Bar Loop Roll
Pad 4 Select previous loop slot 1 Bar Loop Roll
Pad 5 Set loop out point (If loop in point is
set), Adjust loop out point (Loop active)
2 Bar Loop Roll
Pad 6 Set loop in point (Loop not active),
Adjust loop in point (Loop active)
4 Bar Loop Roll