User Manual

30
MAINTENANCE
MAINTENANCE
WARNING! Any maintenance works on the Electric
Brushcutter shall be performed only when the tool is
unpluggedfromthemains.
Cleaning the product
After each use, remove build-up of grass clippings from the inner
surface of the safety guard, as well as from the motor cooling
holesusingabrushorcompressedaircan(cylinder)forcleaning.
Gearbox
Check lubrication of the gearbox once every three months. If
necessary,replacethegreaseorcontactanauthorizedservicecentre.
Changing line in the trimmer spool
WARNING!Thelineischangedwithoutdisassemblingthe
spool.
STEP 1.Measureandcutabout4metersofline,folditinhalf.
STEP 2. Align all arrows on the spool body by rotating theknob
(Fig. 8, page 37).
STEP 3.Inserttwoendsofthelineintotheslotinthespoolknoband
pushthroughuntilitcomesoutfromthesideguidingholes.
STEP 4. Pullthe line all the way. Then feed the line to the
spoolbyrotatingtheknob(Fig. 9, page 37).
WARNING! All other maintenance works shall be carried
outonlybytechniciansofservicecentres.