User Manual

28
PREPARINGFOROPERATIONANDGETTINGSTARTED
Preparing for operation and getting started
Assembly operation
Connect the metal rod to the handle. Attach the straps to the tank.
Adjustthestrapssothatthetoolbaseplatefitssnuglyandcomfortably
onyourback.
Donotusethesprayerifitisnotfullyassembledorisdamaged.Inspect
thesprayertomakesureitisinonepiece.Donotusesubstancesthat
donotdissolveinwaterbecausetheycanclogthefilter.Themaximum
temperatureofthesprayliquidis+43°C.Donotusethesprayerifthe
ambient temperatureis above+45 °C or below 0 °C. Do not use the
sprayerifthereisnoliquidinthetank.
• Chargethebatterycompletelybeforeuse.Tochargethebattery,
connecttheoutputconnectorofthemainsadaptertothecharger
connectorinthesprayerhousing.Theninserttheplugofthe
adaptercableintoa220VAC/50Hzelectricaloutlet.
• Pourtheliquidintothesprayerthroughthetopfillingfilter.
• Turnonpower.
• Pressthehandletostartspraying.
• Releasethehandletostopspraying.
• Changethespraynozzlestoselectthedesiredspraytype.
Criteria for extreme limit states of battery sprayers:
• incaseofdeformationordisturbanceofwatersupplyintegrity,itis
necessarytoreplaceit;
• ifanyplasticpartsarefoundtobebroken,replacethem;
• ifleaksofworkingsolutionaredetectedfromthetank,itis
necessarytoreplacethetank.
Cleaning and maintenance
Afterusingthesprayer,completelyremovethesolutionfromthetank
andrinsethetank,hose,pump,rodandnozzleswithcleanwater.This
will eliminate the possibility of a chemical reaction occurring when
other chemicalsare used in the future. If chemical residuesare not
removed,theycanleadtocorrosionandotherdamagestopartsofthe
sprayer.Thisisespeciallytruefornozzles,filtersandseals.