User manual

ManualsBrandsSequential ManualsKeys10-Voice Polyphonic Analog Synthesizer

Table Of Contents

Welcome Back, Old Friend
Chapter 1: Getting Started
Rear Panel Connections
- Using USB
Setting Up the Prophet-5
- Calibrating the Oscillators and Filters
- Sound Banks
- Selecting Programs
- Editing Programs
- How to Check a Parameter Setting in a Preset
- Comparing an Edited Program to its Original State
- Creating a Program from Scratch
- Live Panel Mode
- Saving a Program
- Canceling Save
  - Comparing Before You Save
Exploring the Prophet-5
Chapter 2: Prophet-5 Controls
Global Settings
- Globals - Top Row
- Globals - Bottom Row
Oscillators
- Oscillator Controls
Mixer
Filter
- Filter Controls
Filter Envelope
- Filter Envelope Controls
Amplifier Envelope
- Amplifier Envelope Controls
Low Frequency Oscillator
- LFO Controls
Wheel-Mod Controls
- Using LFO and Wheel-Mod
Poly Mod
- Poly Mod Parameters
Using the Vintage Knob
Pitch and Mod Wheels
- Pitch Wheel
- Mod Wheel
Adding Aftertouch
Glide Rate
Unison
- Using Chord Memory
Master Tune
The Release Switch
The Tune Button
Key Priority Modes
- About Voice Assignment
Chapter 3: Creating Sounds
Synth Bass
- Short Version
  - Long Version
Creating Synth Brass
- Turning Synth Brass into a String Pad
Creating a Hard-Sync Lead
- A Final Word
Chapter 4: Using CVs and Gates
- Using Prophet-5’s CV Out
- Adjusting the Prophet-5’s CV Output Scaling:
- Adjusting the Prophet-5’s CV Input Scaling:
- Using Prophet-5’s Gate In and Gate Out
Appendix A: Troubleshooting and Support
- Troubleshooting
- Resetting the Global Parameters
- Contacting Technical Support
- Warranty Repair
Appendix B: Calibrating the Prophet-5
- Calibrating the VCOs and Filters
- Calibrating the Pitch and Mod Wheels
- Resetting the Global Parameters
Appendix C: Exporting and Importing Programs/Banks
- Importing Programs and Banks
Appendix D: Alternative Tunings
- 1. 12-Tone Equal Temperament (non-erasable)
Bookmark 1
Bookmark 1

Master Tune

Sequential

Master Tune

The master tune control allows you to manually tune the Prophet-10

to the A440 reference tone or to an external reference such as another

instrument. It has a tuning range of approximately a semitone (half step)

sharp or at. This knob has a center detente, and when in the center posi-

tion, the Prophet-10 should be at concert pitch.

The Master Tune and A440 reference tone controls

To manually tune the Prophet-10 to A440:

1. Recall the basic preset by holding down record and pressing preset.

2. Hold down an “A” in the middle of the keyboard.

3. Press the a440 switch. The Prophet-10 generates an A440 reference

tone.

4. Turn the master tune knob until you match the pitch of the A440

reference tone.

5. When you’re done, press the a440 switch again to turn off the refer-

ence tone.