User manual

39
Prophet-10 User’s Guide
Glide Rate
In the case of Filter aftertouch, pressing a key harder will open the lter
wider, increasing the brightness of the sound. In the case of LFO modula-
tion, pressing a key harder will apply modulation to the currently enabled
destinations in the wheel-mod section.
To enable aftertouch (pressure) as a source for modulation:
1. Press the aftertouch switch once to select Filter modulation.
2. Press the aftertouch switch twice to select LFO modulation.
3. Press the aftertouch switch three times to select both Filter modulation
and LFO modulation.
4. Hold down a note on the keyboard, then press harder. Modulation is
applied to the selected destination(s).
The Prophet-10 provides eight different aftertouch/pressure response settings.
To choose a different response curve, use the at response parameter in the globals
parameters. See page 16 for more information.
Glide Rate
Glide causes the pitch of a note to glide up or down from the pitch of
the previously played note. On the Prophet-10, glide operates on a given
voice whenever that voice changes to a different note. It functions when the
Prophet-10 is in either polyphonic or Unison mode.
To use Glide:
1. Turn the glide rate knob to approximately 4.
2. Play a series of notes up and down the keyboard while you continue to
turn the glide rate knob to adjust the amount of glide.