User manual
Table Of Contents
- Welcome Back, Old Friend
- Chapter 1: Getting Started
- Rear Panel Connections
- Setting Up the Prophet-5
- Exploring the Prophet-5
- Chapter 2: Prophet-5 Controls
- Global Settings
- Oscillators
- Mixer
- Filter
- Filter Envelope
- Amplifier Envelope
- Low Frequency Oscillator
- Wheel-Mod Controls
- Poly Mod
- Using the Vintage Knob
- Pitch and Mod Wheels
- Adding Aftertouch
- Glide Rate
- Unison
- Master Tune
- The Release Switch
- The Tune Button
- Key Priority Modes
- Chapter 3: Creating Sounds
- Synth Bass
- Creating Synth Brass
- Creating a Hard-Sync Lead
- Chapter 4: Using CVs and Gates
- Appendix A: Troubleshooting and Support
- Appendix B: Calibrating the Prophet-5
- Appendix C: Exporting and Importing Programs/Banks
- Appendix D: Alternative Tunings
- 1. 12-Tone Equal Temperament (non-erasable)
- 2. Harmonic Series
- 3. Carlos Harmonic Twelve Tone
- 4. Meantone Temperament
- 5. 1/4 Tone Equal Temperament
- 6. 19 Tone Equal Temperament
- 7. 31 Tone Equal Temperament
- 8. Pythagorean C
- 9. Just Intonation in A with 7-Limit Tritone at D#
- 10. 3-5 Lattice in A
- 11. 3-7 Lattice in A
- 12. Other Music 7-Limit Black Keys in C
- 13. Dan Schmidt Pelog/Slendro
- 14. Yamaha Just Major C
- 15. Yamaha Just Minor C
- 16. Harry Partch 11-Limit 43 Note Just Intonation
- 1. 12-Tone Equal Temperament (non-erasable)
- Bookmark 1
- Bookmark 1
32
Wheel-Mod Controls
Sequential
LFO Controls
Initial Amount: 0...10—Sets the amount of LFO modulation routed to a
destination set in the wheel-mod section. Setting an amount here applies
the selected modulation continuously. If you set this parameter to zero
but still select a modulation destination in the wheel-mod section, modu-
lation is only applied when you use the Mod wheel.
Frequency: 0...10—Sets the frequency of the selected LFO from a slow
.022Hz to a fast 500Hz.
Shape: Sawtooth, Triangle, Square—This button sets the waveshape of
the selected LFO. Any of these waveshapes can be enabled simultaneously.
Wheel-Mod Controls
The Wheel-Mod controls assign the LFO and Noise modulation sources
to a variety of destinations. Use the initial amount control in the LFO
section to apply the selected modulation continuously, or if initial
amount is set to 0, use the Mod wheel to apply the modulation effect.
Source Mix: LFO, Noise—Sets the ratio between two modulation
sources: LFO and Noise. When set fully counter-clockwise, the modula-
tion source is LFO only. When set fully clockwise, the modulation source
is Noise only. Settings between these two extremes provide a variable
mix of the two sources.
Freq A: Routes the LFO and/or Noise modulation source to Osc A
frequency.
Freq B: Routes the LFO and/or Noise modulation source to Osc B
frequency.
PW A: Routes the LFO and/or Noise modulation source to Osc A square
wave pulse width.
PW B: Routes the LFO and/or Noise modulation source to Osc B square
wave pulse width.
Filter: Routes the LFO and/or Noise modulation source to Filter cutoff
frequency.