User Manual

76 System Settings Dave Smith Instruments
When set to Disabled, the latCh on buttons simply switch between FX1 and
FX3 or FX2 and FX4 and the latch function is disabled.
For more details about
latCh on, see “Real Time FX” on page 35.
5. Envelope Amount Encoder behavior: Normal, Shift Switched— In
Shift Switched mode, the un-shifted (
amount) and shifted (veloCity amount)
behaviors are swapped. That is, when
Shift is off, the encoder controls veloCity
amount and when on, amount.
6. Select Sound behavior: Shift On + Pad, Shift Held + Pad— The default
behavior is
Shift Held + Pad. To select a Sound for editing without playing the
Sound, hold
Shift down and press the desired pad. When set to Shift Held + Pad,
the pads can still be played when
Shift is on.
When set to Shift On + Pad,
Shift must either be on or held down to select the
Sound.
7. Tap Tempo behavior: Shift On + Play, Shift Held + Play— With
Tempest’s default behavior (Shift Held + Play), must be held to tap the tempo.
Otherwise, Play starts/restarts the Beat, whether Shift is on or not. When set to
Shift On + Play, Play is used to tap the tempo when Shift is either on or held
down.
System: System Actions
1. Calibrate Analog Oscillators and Filters: Tempest’s analog waveshapes
and lters are calibrated at the factory and should not need to be recalibrated
unless you are experiencing problems.
2. Calibrate Slider 1 and 2 Position: Tempest’s Sliders are calibrated at the
factory and should not need to be recalibrated unless you are experiencing prob
-
lems.
3. Calibrate Drumpads: Tempest’s Sliders are calibrated at the factory and
should not need to be recalibrated unless you are experiencing problems.
4. Reset System Parameters: Resets all the system parameters to their default
values.
5. Show System Information: Displays the current versions of the operating
systems.