User Manual

67
Pro 2 Operation Manual
Touch Sliders
Use the mod matrix to assign modulation destinations to the sliders. You
can route multiple modulation destinations to a slider. To display the
modulation matrix, press the aSSign Source or aSSign deSt buttons in the
Modulation section. Modulations slots and routings appear in the OLED
display.
DestinationEdit Mod 1 Source Amount
Sort SourceSlot Sort
Mod 1
Mod 2
Mod 3
Mod4
Slider 1 Position
Slider 2 Postion
Aftertouch
Mod Wheel
60
35
25
80
F1 Cuto
F1 Resonance
Drive
Sub Osc Level
Sort Dest
To assign a slider to a mod destination:
1. On the front panel mod section, press and hold the aSSign Source button.
2. Touch slider 1. The mod matrix appears in the display and Slider 1
poSition is assigned to an available modulation slot.
To assign slider pressure instead of position, tap the slider a second time.
3. Turn soft knob 4 (deStination) to choose a modulation destination.
4. Turn soft knob 3 (
amount) to choose the maximum amount of modula-
tion applied when the mod wheel is turned all the way up.
5. To route the slider to more destinations, turn soft knob 1 (
edit mod #) to
nd an open modulation slot and choose Slider 1 poSition (or pressure).
6. Repeat steps 3-4.