User Manual

51
Pro 2 Operation Manual
Sequencer
Use the bpm, clock divide, or tap tempo controls to adjust sequencer playback
speed.
To transpose a sequence up or down, hold down a note on the keyboard
above or below middle C. Middle C plays the sequence as recorded. For greater
range, use the Transpose Up or Transpose Down buttons.
To record over an existing note sequence:
1. Make sure the Sequencer button is on.
2. If a sequence is running, press play/Stop to stop it.
3. Press the record button.
4. Play different notes on the keyboard. The numbered step LEDs indicate
which step you’re on.
5. When you’re done, press play/Stop to listen to the new sequence.
To erase an existing sequence:
1. Press and hold the track Select button.
2. Turn soft knob 1 (Select track) to select the desired sequencer track.
3. Press soft key 4 to execute the clear track command.
4. Release the track Select button.
Recording Additional Sequencer Tracks for Modulation
Track 1 of the sequencer is permanently routed to the oscillators. But
other sequencer tracks can be routed to any modulation destination.
Here’s how to sequence lter cutoff modulation on Track 2.
To modulate Filter 1 cutoff frequency using sequencer Track 2:
1. Press and hold the track Select button then press sequencer step LED
2. (Alternatively, turn soft knob 1 (Select track) to select track 2.)
2. While continuing to hold down the track Select button, turn soft knob
4 (deSt) to select f1 freq.
3. Release the track Select button.