User Manual
Table Of Contents
- Thank You
- Getting Started
- Connections
- Global Settings
- Oscillators
- Character
- Filter 1 & 2
- Filter Envelopes 1 & 2
- Amplifier Envelope
- Auxiliary Envelopes 4 & 5
- Low Frequency Oscillators
- Modulation
- Arpeggiator
- Sequencer
- Master Volume/Voice Volume
- Distortion
- Glide
- Pitch and Modulation Wheels
- Touch Sliders
- Play List
- Misc Parameters
- Using USB
- A Few Tutorials
- Appendix A: Modulation Sources
- Appendix B: Modulation Destinations
- Appendix C: Delay Times (Delays 1-3)
- Appendix D: MIDI Implementation
- Appendix E: Support
- Bookmark 1
- _GoBack
- Bookmark 1
- MIDI_Implementation
- _Ref259391539
- _GoBack
- MIDI_messages
- _Ref47692693
- _Ref47691913
- _Ref47691938
- _Ref47692569
- _Ref47692613
- _Ref47692643
9
Pro 2 Operation Manual
Connections
1 2
3 4 5 6 7 8 9 10
USB
1
100-240 VAC
50-60 Hz
30 Watts
Pedal Right
Left
Footswitch
MIDI In
MIDI Out
MIDI Thru/
Out 2
Audio Out
CV In
2 3 4 1
CV Out
2 3 4
Gate
Out
Audio In Headphones
6. Control Voltage Ins and Outs 1-4—Standard ⅛ inch TS connectors.
These jacks input and output a scalable 1-volt-per-octave signal for
interfacing with modular synthesizers and other gear that recognize this
standard.
7. Gate Out—Standard ⅛ inch TS connector. This jack outputs a 10 volt
on/off signal for triggering external sequencers and other devices that
support this type of connectivity.
8. Audio In—Unbalanced, ¼ inch audio input. The Pro 2 accepts exter-
nal audio signals for processing through this connector. Input level can
be adjusted using the ext. input level knob in the Oscillators section.
9. Audio Outputs—Unbalanced, ¼ inch audio outputs. The Pro 2 sounds
great in stereo, but can be switched to mono if needed. See “Mono/
Stereo” in Global Settings on page 11.
10. Headphones—A ¼ inch stereo headphone jack.