User Manual

Modulators

Modulators lets you configure the modulation routing and amount for Mopho

x4’s four general-purpose modulation slots.

Since each Mopho x4 modulation source has a single destination, the four

general purpose modulators provide a way to send a mod source (such as a

sequence or LFO) to additional destinations, with a different amount. There are

also additional mod sources available here, such as Noise, allowing a wide

variety of possibilities.

To configure a general-purpose modulation slot, select M

ODULATORS and

choose the appropriate modulator: 1, 2, 3, or 4. Then use the S

OURCE,

ESTINATION, and AMOUNT parameters to route the modulation as desired.

Source—Selects a modulation source. See Modulation Sources on page 32 for

possible sources.

Amount: -127…+127—Sets the amount of modulation.

Destination—Selects a modulation destination. See Modulation Destinations on

page 33 for a list of possible destinations.