User Manual

17
Envelopes
Mopho x4 has three 5-stage (Delay + ADSR) envelope generators per voice.
Two are dedicatedone to the filter and the other to the amplifierand the
third is assignable to any modulation destination.
Envelope SelectSelects the envelope to edit. When all three are lighted, the
other envelope parameters control all three envelopes simultaneously.
Amount: -127...127Sets the amount of modulation from the envelope to the
destination: filter, amplifier, or the selected destination for envelope 3. The
modulation amount can be positive or negative, allowing for inverted envelope
control. (For the VCA, the range is 0-127, since you can't have a negative gain
on a VCA!)
Delay: 0...127Sets a delay between the time the envelope is gated on and
when the Attack portion actually begins
Attack: 0...127Sets the attack time of the selected envelope(s).
Decay: 0...127Sets the decay time of the selected envelope(s).
Sustain: 0...127Sets the sustain time of the selected envelope(s).
Release: 0...127Sets the release time of the selected envelope(s).
Velocity: 0...127Sets the amount of key velocity used to modulate the
envelope amount.
Other Envelope Parameters
There are two additional parameters for envelope 3 in the Miscellaneous
Parameters section.
Envelope 3 DestinationSets the destination modulated by envelope 3. See
Modulation Destinations on page 33 for a list of possible destinations.
Envelope 3 Repeat: Off, OnWhen on, causes the delay, attack, decay, and
sustain portions of Envelope 3 to loop for as long as the envelope is gated on.
With repeat on, envelope 3 can even be used as a sort of complex LFO.