User Manual

Miscellaneous Audio Parameters
Output Hack: 5 8 0…14
Trashes the output signal, quite rudely.
Distortion: 5 8 S o0…99, i0…99 Amount of distortion. If set to o00 to o99, the
distortion is after the analog filter and VCA, before the Delay. If set to i00 to i99, the
distortion is before the analog filter, and only affects external input. There are two
separate distortions, one for each channel.
Note - there is a built-in noise gate that is enabled when distortion is not zero. If
you want to use the noise gate but without distortion, use a distortion setting of
i01 (noise gate on input signal), or o01 for a noise gate after the analog
electronics. The noise gate uses the Left channel signal level to gate both
channels.
Noise Vol: 8 5 0…100 The volume of white noise mixed into the filter. The same
amount goes into both channels.
Ext In Vol: 8 6 0…100 The volume of external audio input connected to Left In
and/or Right In.
Ext In Mode: 8 7 see table Selects the external input mode:
Display External Audio Input Mode
st
Stereo – the left channel in goes to the left channel, right to right.
l
Left – the left channel in goes to both channels (mono in).
R
Right – the right channel in goes to both channels (mono in).
spl
Split - A mono audio signal is input on the Left Input; a separate
control audio signal (for envelope follower, peak hold, and clock
source) into the Right Input.
Input Hack: 8 8 0…14 Trashes the external input signal, quite rudely. But, the
analog filter tames it nicely. A good way to mess up a clean stereo signal.
32