User Manual
Table Of Contents
- A Few Words of Thanks
- Chapter 1: Getting Started
- Rear Panel Connections
- Setting Up the Pro 3
- Using the Main Display
- Sound Banks
- Editing Programs
- Saving a Program
- Using Paraphonic Mode
- Exploring the Pro 3 in Greater Depth
- Chapter 2: Pro 3 Controls
- Oscillators
- Mixer
- Filters
- Amplifier Envelope
- Auxiliary Envelopes
- Low Frequency Oscillators
- Modulation
- Effects
- Arpeggiator
- Sequencer
- Normal, Gated, and Trigger Modes
- Programming the Sequencer
- Recording Phrases/Sequences A,B,C, or D.
- Sequencing Parameter Changes in Real-Time
- Copying a Sequence from One Track to Another
- Copying and Pasting an Entire Sequence
- Muting a Sequence Track
- Creating An Extended Sequence
- Paraphonic Sequencing
- Adding Rests, Ties, and Velocity
- Editing Duration
- Adding Ratcheting
- Editing Other Elements of a Sequence
- Setting or Changing the Destination of a Track
- Recording Additional Sequencer Tracks for Modulation
- Using Slew
- Turning off the Sequencer’s “Notes” Track
- Sequencer Parameters (Front Panel)
- Additional Sequencer Parameters (Display Menus)
- Cue Program
- Tuned Feedback
- Master Volume/Program Volume
- Transpose
- Hold
- Glide
- Pitch and Mod Wheels
- Touch slider
- Adding Aftertouch
- Distortion
- Play List
- Miscellaneous Parameters
- Global Settings
- Chapter 3: Programming the Pro 3
- Synthesis 101: Synth Bass
- Creating Synth Brass
- Creating a Hard-Sync Lead
- Chapter 4: Using the Pro 3 with External Devices
- Appendix A: Modulation Sources
- Appendix B: Modulation Destinations
- Appendix C: Troubleshooting and Support
- Appendix D: Calibrating the Pro 3
- Appendix E: Alternative Tunings
- Appendix F: MIDI Implementation
- Bookmark 1
- Bookmark 1
52
Effects
Sequential
To use Effects:
1. Press the effect 1 button to turn on effect 1.
1. Press Soft Button 2 (fx1 params) in the display to select effect 1 for
editing.
2. Turn the effect type knob to choose an effect.
3. Turn the mix knob to blend in a good amount of the processed signal.
You’ll want to be able to clearly hear the effect when you tweak its
settings. You can dial it down afterward.
4. Use the param 1, param 2, and param 3 knobs to adjust the effect’s
parameters to your taste. See “Effects Parameters” on page 52 for
details on the adjustable parameters on each effect type.
5. Finally, adjust the mix knob again to optimize the amount of the effect.
Full left is completely dry. Full right is completely wet (a 100%
processed signal).
6. To sync a delay to the Arpeggiator or Sequencer, enable its sync param-
eter and adjust the time parameter (Parameter 1) as needed.
Effects Parameters (Front Panel)
Effect 1: Turns effect 1 on or off.
Effect 2: Turns effect 2 on or off.
Effect Type: stereo delay, bbd delay, chorus, anger, phaser, HP lter,
ring mod, rotating speaker, super plate—Selects the effect type.
Show Effects: Shows the Effects menu in the display for editing. Press-
ing this button more than once toggles between the two effects in the
display.
Mix: 0...127—Sets the balance between the processed (wet) signal
and unprocessed (dry) signal. Full left is completely dry. Full right is
completely wet.