User Manual
Table Of Contents
- A Few Words of Thanks
- Chapter 1: Getting Started
- Rear Panel Connections
- Setting Up the Pro 3
- Using the Main Display
- Sound Banks
- Editing Programs
- Saving a Program
- Using Paraphonic Mode
- Exploring the Pro 3 in Greater Depth
- Chapter 2: Pro 3 Controls
- Oscillators
- Mixer
- Filters
- Amplifier Envelope
- Auxiliary Envelopes
- Low Frequency Oscillators
- Modulation
- Effects
- Arpeggiator
- Sequencer
- Normal, Gated, and Trigger Modes
- Programming the Sequencer
- Recording Phrases/Sequences A,B,C, or D.
- Sequencing Parameter Changes in Real-Time
- Copying a Sequence from One Track to Another
- Copying and Pasting an Entire Sequence
- Muting a Sequence Track
- Creating An Extended Sequence
- Paraphonic Sequencing
- Adding Rests, Ties, and Velocity
- Editing Duration
- Adding Ratcheting
- Editing Other Elements of a Sequence
- Setting or Changing the Destination of a Track
- Recording Additional Sequencer Tracks for Modulation
- Using Slew
- Turning off the Sequencer’s “Notes” Track
- Sequencer Parameters (Front Panel)
- Additional Sequencer Parameters (Display Menus)
- Cue Program
- Tuned Feedback
- Master Volume/Program Volume
- Transpose
- Hold
- Glide
- Pitch and Mod Wheels
- Touch slider
- Adding Aftertouch
- Distortion
- Play List
- Miscellaneous Parameters
- Global Settings
- Chapter 3: Programming the Pro 3
- Synthesis 101: Synth Bass
- Creating Synth Brass
- Creating a Hard-Sync Lead
- Chapter 4: Using the Pro 3 with External Devices
- Appendix A: Modulation Sources
- Appendix B: Modulation Destinations
- Appendix C: Troubleshooting and Support
- Appendix D: Calibrating the Pro 3
- Appendix E: Alternative Tunings
- Appendix F: MIDI Implementation
- Bookmark 1
- Bookmark 1
10
Saving a Program
Sequential
You can also recall the Basic Program by simultaneously pressing the trans-
pose down and the touch slider’s latch button.
Chapter 3 provides a selection of simple sound design tutorials. It’s designed
to give you a basic working knowledge of how to use the Pro 3 to make your
own sounds. See “Chapter 3: Programming the Pro 3” on page 104.
Saving a Program
If you’ve created a sound that you like, you’ll probably want to save it.
Saving a program overwrites a previously saved program. Sound design-
ers often save many incremental versions of a program as they continue
to rene it. These intermediate versions often make good jumping off
points for new sounds.
To save a program to the same preset location:
1. Press the write button. Its LED begins blinking.
2. Enter a name for the program using the appropriate Soft Knobs and
Soft Button. (See the illustration that follows for their functions.)
3. Press the write button again. Its LED stops blinking and the program is
saved.
To save a program to a different location:
1. Press the write button. Its LED begins blinking.
2. Turn the bank or program knobs (or Soft Knob 1 and Soft Knob 2) to
select a new location. You can only save to banks U1-U4.
3. Enter a name for the program using the appropriate Soft Knobs and
Soft Buttons. (See the illustration that follows for their functions.)
Press the write button again. Its LED stops blinking and the program is
saved.