User Manual
Table Of Contents
- A Few Words of Thanks
- Chapter 1: Getting Started
- Rear Panel Connections
- Setting Up the Pro 3
- Using the Main Display
- Sound Banks
- Editing Programs
- Saving a Program
- Using Paraphonic Mode
- Exploring the Pro 3 in Greater Depth
- Chapter 2: Pro 3 Controls
- Oscillators
- Mixer
- Filters
- Amplifier Envelope
- Auxiliary Envelopes
- Low Frequency Oscillators
- Modulation
- Effects
- Arpeggiator
- Sequencer
- Normal, Gated, and Trigger Modes
- Programming the Sequencer
- Recording Phrases/Sequences A,B,C, or D.
- Sequencing Parameter Changes in Real-Time
- Copying a Sequence from One Track to Another
- Copying and Pasting an Entire Sequence
- Muting a Sequence Track
- Creating An Extended Sequence
- Paraphonic Sequencing
- Adding Rests, Ties, and Velocity
- Editing Duration
- Adding Ratcheting
- Editing Other Elements of a Sequence
- Setting or Changing the Destination of a Track
- Recording Additional Sequencer Tracks for Modulation
- Using Slew
- Turning off the Sequencer’s “Notes” Track
- Sequencer Parameters (Front Panel)
- Additional Sequencer Parameters (Display Menus)
- Cue Program
- Tuned Feedback
- Master Volume/Program Volume
- Transpose
- Hold
- Glide
- Pitch and Mod Wheels
- Touch slider
- Adding Aftertouch
- Distortion
- Play List
- Miscellaneous Parameters
- Global Settings
- Chapter 3: Programming the Pro 3
- Synthesis 101: Synth Bass
- Creating Synth Brass
- Creating a Hard-Sync Lead
- Chapter 4: Using the Pro 3 with External Devices
- Appendix A: Modulation Sources
- Appendix B: Modulation Destinations
- Appendix C: Troubleshooting and Support
- Appendix D: Calibrating the Pro 3
- Appendix E: Alternative Tunings
- Appendix F: MIDI Implementation
- Bookmark 1
- Bookmark 1
88
Touch slider
Sequential
Touch slider
The Pro 3 has a position-sensitive Touch slider. Like the Pitch and Mod
wheels, you can use this slider to enhance live performance by adding
modulation in real time as you play.
The slider serves as a modulation source, the value of which is deter-
mined by nger position. The Touch slider appears in the modulation
matrix as slider. (See page 120 for a list of mod destinations.)
Normally, the slider affects the assigned modulation destinations only
while it’s being touched. But when latch is on, the Touch slider holds
the value from the position at which it was last touched.
TOUCH
The Touch slider
Use the mod matrix to assign modulation destinations to the slider. You
can route multiple modulation destinations to the slider. To display the
modulation matrix, press the source or destination buttons in the Modu-
lation section. Modulation slots and routings appear in the display.
DestinationEdit Mod 1 Source Amount
Sort SourceSlot Sort
Mod 1
Mod 2
Mod 3
Mod 4
Slider
LFO 2t
Aftertouch
Mod Wheel
60
35
25
80
Cuto
Osc1 Shape
Drive
LFO1 Amt
Sort Dest