User Manual

71
Pro 3 User’s Guide
Sequencer
To add ties to an existing sequence:
1. To show the track in the display, hold down the track sel button and
press the step LED with the same number as the track you want to edit
(step 1 = track 1, and so on).
2. Release the track sel button. The track appears in the display.
3. On the front panel, press and continue to hold the LED button for the
step where the tie will start.
4. Press the LED button for the step where the tie will end.
5. Release the buttons.
6. To create additional ties, repeat steps 3-5.
Editing Velocity
When you use the keyboard to record note sequences in real time,
the Sequencer records note velocity along with the note values. The
sequence editor allows you to edit these values.
To edit velocity on an existing sequence:
1. To show the notes track in the display, hold down the track sel button
and press step LED 1 (notes/vel). Note that if the sequence is para-
phonic, tracks 2 and 3 are also note tracks.
2. Release the track sel button. The notes track appears in the display.
3. Press Soft Button 1 (velocity) to display the velocity parameter for the
track.
4. Turn Soft Knob 1 (step) to scroll to the desired step.
5. Turn Soft Knob 4 (vel) to edit the velocity value of the selected step.
6. Repeat steps 4 and 5 as desired.
Velocity is only available for editing on note tracks or tracks that have (MIDI)
Out 1 or Out 2 as their destination.
If you have a Sequencer track assigned to a MIDI channel output and it is only
sending MIDI note-off messages, check the value of the Velocity parameter for each step.
A velocity greater than zero must be set for a MIDI note-on message to be sent. If the
velocity for a given step is set to zero, only a MIDI note-off message will be sent for that step.