User Manual
Table Of Contents
- A Few Words of Thanks
- Chapter 1: Getting Started
- Rear Panel Connections
- Setting Up the Pro 3
- Using the Main Display
- Sound Banks
- Editing Programs
- Saving a Program
- Using Paraphonic Mode
- Exploring the Pro 3 in Greater Depth
- Chapter 2: Pro 3 Controls
- Oscillators
- Mixer
- Filters
- Amplifier Envelope
- Auxiliary Envelopes
- Low Frequency Oscillators
- Modulation
- Effects
- Arpeggiator
- Sequencer
- Normal, Gated, and Trigger Modes
- Programming the Sequencer
- Recording Phrases/Sequences A,B,C, or D.
- Sequencing Parameter Changes in Real-Time
- Copying a Sequence from One Track to Another
- Copying and Pasting an Entire Sequence
- Muting a Sequence Track
- Creating An Extended Sequence
- Paraphonic Sequencing
- Adding Rests, Ties, and Velocity
- Editing Duration
- Adding Ratcheting
- Editing Other Elements of a Sequence
- Setting or Changing the Destination of a Track
- Recording Additional Sequencer Tracks for Modulation
- Using Slew
- Turning off the Sequencer’s “Notes” Track
- Sequencer Parameters (Front Panel)
- Additional Sequencer Parameters (Display Menus)
- Cue Program
- Tuned Feedback
- Master Volume/Program Volume
- Transpose
- Hold
- Glide
- Pitch and Mod Wheels
- Touch slider
- Adding Aftertouch
- Distortion
- Play List
- Miscellaneous Parameters
- Global Settings
- Chapter 3: Programming the Pro 3
- Synthesis 101: Synth Bass
- Creating Synth Brass
- Creating a Hard-Sync Lead
- Chapter 4: Using the Pro 3 with External Devices
- Appendix A: Modulation Sources
- Appendix B: Modulation Destinations
- Appendix C: Troubleshooting and Support
- Appendix D: Calibrating the Pro 3
- Appendix E: Alternative Tunings
- Appendix F: MIDI Implementation
- Bookmark 1
- Bookmark 1
59
Pro 3 User’s Guide
Arpeggiator
Repeats: 1, 2, 3 —Set to 1, each note in the arpeggio plays once. Set to
2, each note in the arpeggio plays twice. Set to 3, each note in the arpeg-
gio plays three times.
Clock Parameters
BPM: 30…250—Sets the tempo for the Arpeggiator in BPM (beats per
minute). The tap tempo LED ashes at the BPM rate. When sync is enabled
on the low-frequency oscillator, or enabled in the Effects section, the BPM
rate affects the LFO frequency and/or delay effect. When syncing to an exter-
nal MIDI clock source, the BPM setting has no effect.
Divide—Selects a basic note value relative to the BPM. See the table below:
Name Tempo Timing Division
Half BPM/2 Half note
Quarter BPM Quarter note
8th BPM x 2 Eighth note
8 Trip BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16 Trip BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
32 Trip BPM x 12 Thirty-second note triplets
64th BPM x 16 Sixty-fourth note
Tap Tempo—Pressing the tap tempo button 4 times sets the tempo. The
LED ashes at the BPM rate you set.