User Manual

38
Amplier Envelope
Sequential
Additional Amplier Parameters (Display Menus)
Additional Amplier Envelope parameters are accessible through the
menus in the main display. To see these menus, adjust any of the controls
in amp portion of the envelopes section of the front panel. The parameters
explained below are the ones that don’t appear on the front panel.
TAB 1 - VCA
Attack
VCA ADSR VCA Env AmtFXVCA
VOLUME
127
Volume: 0...127—Sets the volume of the currently active program.
Although the master output level of the Pro 3 is controlled by the front-
panel master volume knob, the volume parameter in this menu sets the
volume of an individual program. This is useful for ensuring that your
sounds have roughly the same volume from program to program.
TAB 4 - VCA Env Amount
Amt: 127
Amount DelayVel On/O Env Loop
Vel: O
Loop: O
Del: 0
VCA ADSR VCA Env AmtFXVCA
Delay: 0...127—Sets a delay between the time the envelope is triggered
(note on) and when the attack portion actually begins.
Loop: Off, On—When on, the Delay, Attack, and Decay segments of
the envelope repeat. Sustain still affects the level at which the Decay
segment ends, but instead of sustaining at a xed level while a note is
gated on, Delay, Attack, and Decay loop until the note is turned off. The
Release segment begins when the note is gated off, just as it does when
Repeat is off.