User Manual

58 Aftertouch Dave Smith Instruments
VCO 2: Selects Oscillator 2 frequency as an aftertouch modulation desti-
nation. With a positive amount setting, pressing the keys harder will shift
the Oscillator 2 pitch upward. With a negative amount setting, pressing
the keys harder will shift the Oscillator 2 pitch downward.
LFO Amount: Selects the lfo amount parameter as an aftertouch modu-
lation destination. With a positive
amount setting, pressing the keys
harder will increase the amount of LFO modulation to any destina-
tion selected in the
low-frequency oscillator section. With a negative
amount setting, pressing the keys harder will increase the amount of
LFO modulation — with the LFO waveform inverted.
Loudness: Selects Amplitude as an aftertouch modulation destination.
With a positive amount setting, pressing the keys harder will increase
the volume of a sound. With a negative
amount setting, pressing the keys
harder will decrease the volume of a sound.
If the Loudness Envelope’s amount is set to full, positive amounts of loudness
aftertouch will have no effect since the VCA is already at its maximum output level.
Filtr Freq: Selects the lter cutoff frequency as a modulation destination.
With a positive amount setting, pressing the keys harder will open the
lter wider and make a sound become brighter. With a negative amount
setting, pressing the keys harder will close the lter more and make a
sound more muted.
Filtr Mode: Selects the Filter Mode as a modulation destination. With a
positive amount setting, pressing the keys harder will move smoothly
between low-pass, notch, and high-pass lter modes.