User Manual

40 X-Mod Dave Smith Instruments
Arpeggiator Parameters
Tap Tempo—Tapping the tap tempo button sets the tempo from 30 to
250 BPM. The LED ashes at the BPM rate you set. Tap the button at
least 4 times to set the tempo.
BPM: 30…250—Sets the tempo for the arpeggiator in BPM (beats per
minute). The tap tempo LED ashes at the BPM rate. When lfo sync is
enabled on the low-frequency oscillator, or clock sync is enabled in the
Effects section, the BPM rate affects the LFO frequency and/or delay effect.
When syncing to an external MIDI clock source, the BPM setting has no effect.
Value—Selects a basic note value relative to the BPM. See the table below:
Name Tempo Timing Division
Half BPM/2 Half note
Qtr BPM Quarter note
8th BPM x 2 Eighth note
8th D BPM x 2 Eighth note, dot
8th S BPM x 2 Eighth note, swing timing
8th T BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16th S BPM x 4 Sixteenth note, full swing timing
16th T BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
On/Off—
Turns the Arpeggiator on and off.
Octave: 1 Octave, 2 Octaves, 3 Octaves—Set to 1 Octave, only the
keyed notes are arpeggiated. Set to 2 Octaves, the keyed notes and the
notes one octave above them arpeggiate. Set to 3 Octaves, the keyed
notes and the notes one and two octaves above them arpeggiate.