User's Manual

6 ST User Manual
Arming the System
Arming the Perimeter
When the system is armed using the Arm Perimeter method, the perimeter zones/sensors
(e.g., exterior doors/windows) will be activated, but the interior zones/sensors (e.g., motion
detectors) will not be activated. Use the Arm Perimeter method when you are staying home.
Close any open protected doors and windows.
Press the ARM PERIM key. Enter a valid user PIN if prompted.
The keypad displays the amount of seconds until the system is armed. Optionally, you
may select <NoDelay> or <LatchKey>*. If neither is selected, the system will proceed
with the exit delay.
At the end of the exit delay, all perimeter doors and windows are armed.
* The Latchkey option will only be presented if it is enabled (Ask your installer.)
Arming All
When the system is armed using the Arm All method, all zones/sensors will be activated
and will cause an alarm when tripped. Use the Arm All method when no one will be stay-
ing on the premises.
Close any open protected doors and windows.
Press the ARM ALL key. Enter a valid user PIN if prompted.
The keypad displays the amount of seconds until the system is armed. Optionally, you
may select <NoDelay> or <LatchKey>*. If neither is selected, the system will proceed
with the exit delay.
At the end of the exit delay, all zones/sensors are armed.
* The Latchkey option will only be presented if it is enabled (Ask your installer.)
No Delay
The system can be armed with no delay by selecting <NoDelay> during the exit delay.
This method provides greater security while you are on the premises and do not require an
exit/entry delay time.
Latchkey Feature
If this option is enabled, the system will present an option to specify a latchkey time when
arming. If you select this option and enter a time, the system will send a report if someone,
such as a child, does not arrive home and disarm the system by the designated time. A report
will be sent to a central monitoring station and/or emailed depending on system configuration.
To set the latchkey time:
Arm the system by pressing ARM ALL or ARM PERI and entering your user PIN.
Select <Latchkey> and enter the latchkey time.
Bypassing Sensors
If the system is armed with open zones, the system will prompt you to bypass the zones. A
bypassed zone will be unprotected and will not cause an alarm while your system is armed.
To bypass zones:
Arm the system using the Arm All or Arm Perimeter method.
The system will identify the open zones, display the exit countdown, and emit an
alternating exit tone.
Select <Bypass> to bypass the open zones or <Cancel> to cancel the arming sequence. If
neither is selected, the system will automatically bypass the open zones and arm at the end
of the exit delay. The bypassed zones will not be activated with the rest of the system.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
1.
2.
3.
Note: If “Quick Arm” is
enabled (ask your installer)
the system will not require
a user code when arming.
Note: If “Quick Arm” is
enabled (ask your installer)
the system will not require
a user code when arming.
Note: If “Auto Home
Arming” is enabled (ask
your installer) and you arm
the system from an LCD
keypad but do not exit
the premises, the system
reverts to Perimeter mode.
Note: If “Auto Home
Arming” is enabled (ask
your installer) and you arm
the system from an LCD
keypad but do not exit
the premises, the system
reverts to Perimeter mode.
Note: Bypassed zones are
automatically cancelled
each time the system is
disarmed.
Note: Bypassed zones are
automatically cancelled
each time the system is
disarmed.