User's Manual

16 ST User Manual

Dialer Test

Perform a dialer test to check the phone communication between the panel and the central

station.

Make sure the system is disarmed.

Press NEXT + NEXT and the keypad will display LOG TEST RESET.

Select <Test> and enter the user PIN. The display will show WALK COMM.

Select <Comm> and the keypad will display “Comm Test Sent.”

Upon a successful communication the keypad will display “Test Succeeded.”

Exit by pressing <Done>.

Wireless Sensor Batteries

Each wireless sensor in your system is powered by at least one 3-volt lithium battery,

which provides years of operation. Actual battery life depends on the environment in

which the sensor is installed, the number of sensor activations, and the specific type of

sensor. If a low battery condition occurs in a wireless sensor, the keypad displays “Low

Battery” along with the zone number. If the wireless sensor is a smoke detector, the detec-

tor emits a single beep approximately every 60 seconds.

NOTE: The system can be

set to automatically send

dialer tests at specied

intervals. Ask your installer

if this feature is enabled.

NOTE: The system can be

set to automatically send

dialer tests at specied

intervals. Ask your installer

if this feature is enabled.

Note: A low battery mes-

sage is a warning that

battery replacement in the

sensor is due within 30

days. In the meantime,

the sensor with the low-

battery condition is fully

operational.