User's Manual

14 ST User Manual
Setting the Time and Date
The installer programs the time and date at the time of installation; however, you can
change it if necessary.
To set the system time:
Enter user setup mode (NEXT + NEXT + NEXT + <Setup> + User PIN).
With the display showing PINS TIME DATE, select <Time>.
Enter the time (hh:mm). Select <AM> or <PM>.
Press <Done> to save and exit the menu.
To set the system date:
Enter user setup mode (NEXT + NEXT + NEXT + <Setup> + User PIN).
Enter user setup menu.
With the display showing PINS TIME DATE, select <Date>.
Enter month/day/year.
Press <Done> to save and exit the menu.
Connecting to the Remote Service Tool (RST)
Although information can be programmed by using the LCD Keypad, some information
may also be programmed remotely from the RST. If remote programming is needed, dis-
cuss the following connection options with your installation company.
To initiate an upload/download session from the panel:
Enter user setup mode (NEXT + NEXT + NEXT + <Setup> + User PIN).
Press NEXT and the display will show “Remote Program.”
Select <Connect> + <Ans> (Answer phone) or <Dial> (Dial phone) or <EIM> (Ethernet).
The system will communicate with the RST using the connection method you selected.
To register for the RST:
Enter user setup mode (NEXT + NEXT + NEXT + <Setup> + User PIN).
Press NEXT and the display will show “Remote Program.”
Select <Regis.> + <EIM> (Ethernet) or <Dialer> (Dial phone).
The system will register with the RST using the connection method you selected.
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.
3.
4.