User's Manual
Maintenance
Cleaning
Place the system in walk test mode.
Remove the detector from the base by turning
counter-clockwise.
Remove the top half of the screen/sensing chamber
by lifting straight up (Figure 4).
Vacuum or use canned air to remove any dust or
particles that are present on both chamber halves.
Replace the top half of the screen/sensing chamber
by aligning the arrow on the screen/sensing chamber
with the arrow on the housing. Press down firmly
until the screen/sensing chamber is fully seated.
Replace the detector cover by placing it over the
screen/sensing chamber and turning it clockwise
until it snaps into place.
Reinstall the detector and test.
REMOVABLE DETECTOR COVER
SCREEN/SENSING CHAMBER
(TOP HALF)
DETECTOR HOUSING
Figure 4: Removing Screen/Sensing Chamber
Battery Replacement
Replace the battery when the smoke alarm or panel
notifies you that the battery is low. When the battery
needs to be replaced, the smoke detector transmits
a signal to the control panel. If the battery is not
replaced within 7 days, the unit will annunciate a
single beep approximately every 60 seconds.
Remove the smoke detector from the base and
remove the battery cover.
Observe correct polarity and insert the battery into
the battery holder.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
Troubleshooting
Problem Actio n
The system
indicates a
sensor trouble
for a wireless
sensor.
A trouble is caused when the sensor
tamper switch is activated — i.e. the
sensor cover is off, not secured, or
the sensor is not mounted properly.
Secure the sensor over and trip sensor
to clear the trouble.
•
The panel does
not respond to
wireless sensors.
There are no
alarm, chime,
or walk test
responses.
Verify that the EXT is enrolled. This
can be done by checking option “EXT
Module” (60401) in the “ST - Modules”
menu in programming. If this option
is 0, the EXT is not recognized by the
system. Remove the EXT and see if a
trouble occurs. If not, replace the EXT.
Bring the wireless sensors closer to
the EXT and test again. If signals are
properly received, the issue may be
related to environmental noise or
interference.
Distance from the receiver and/or
installation environment will affect
the sensor signal strength. Reposition
the sensor and/or EXT if necessary.
•
•
•
The system
indicates a
sensor low
baery.
Replace the sensor’s battery. Test the
sensor after replacing the battery.
Testing the device allows the control
panel to receive a signal with the new
battery information.
•
3